DTS Octo Remote

Post Reply
Posts: 1
Joined: Thu Jan 18, 2018 5:50 pm

DTS Octo Remote

Post by StevenH » Thu Jan 18, 2018 5:52 pm

How do you program these remotes. I have a Magic Lift garage door motor.

Site Admin
Posts: 24
Joined: Fri Jul 21, 2017 10:15 am

Re: DTS Octo Remote

Post by G.Mitchell » Fri Jan 19, 2018 9:01 am

The Remote will have to be programmed into the GDO's receiver. You will need the motors instruction manual for the correct remote "learning" procedure.

Posts: 1
Joined: Sat Feb 16, 2019 12:22 pm

Re: DTS Octo Remote

Post by cobbers » Sat Feb 16, 2019 12:31 pm

i have a gate motor and separate receiver and two remotes supplied withthe receiver and two dts 5 button remotes. the two remotes supplied with the receiver work just fine but the two dts 5 button remotes wont program. one burns the led continiously when a button depressed and the other one led flashes rapidly. any advice, i dont seem to be able to find any remote manual or other instructions on your site.

the receiver instructions are very simple, hold down remote button, short "learn" for few seconds and its done. but what if it is'ent done?

Posts: 25
Joined: Thu Jan 24, 2019 11:50 am

Re: DTS Octo Remote

Post by CHANTELLE » Mon Feb 18, 2019 8:22 am

Good morning,
Could you please advise us which gate motor you have as well as which receiver.
Thank you

Posts: 1
Joined: Tue Mar 17, 2020 11:28 am

Re: DTS Octo Remote

Post by Adrian » Tue Mar 17, 2020 11:31 am

my octo remote flashes green for a split second but does not open the gate. (it used to be red - for as long as you pushed the button) tried everything - change battery, pushed red button first etc.

Posts: 6
Joined: Thu Apr 18, 2019 7:38 am

Re: DTS Octo Remote

Post by Christopher » Thu Mar 19, 2020 2:25 pm

Good day

It may be that the battery if flat, replace and test the remote again.
If the problem persists , please contact us on 012 361 5528, or reply with you contact number so that we can contact you.

Thank you

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest